FAQs

JB-199 (I or II)

a

How do I reset the mother board of JB-199 (I or II) after changing battery or after it has reloaded default settings?

Posted by CAVS on April 18, 2020
As the JB-199 is booting, press DELETE to enter into CMOS Setup Utility. Make the following changes.
  • Standard CMOS Features
  • Drive A [None]
  • Advanced BIOS Features
  • First Boot Device [USB-CDROM]
  • Integrated Peripherals
  • AC97 Audio [Disabled]
  • PC Health Status
  • CPU Smart Fan Control [Disabled]
    • You are done. Please go to Save & Exit Setup on the right side and press Enter, y, Enter to return to boot up.
Category: JB-199 (I or II)
Permalink
a

How to chage the battery on the main board of JB-199 (I or II)

Posted by CAVS on April 18, 2020
  • Power off the Jb-199 unit completely and unplug the power cable.
  • Take the top cover of JB-199 off by removing the 4 screws on each side and 3 screws on the back.
  • On the mainboard, look for a (Quarter) coin size battery CS2302 and remove it by releasing the lock holding the battery. Do not damage the lock in the process.
  • Insert a new CR2032 battery.
  • Power on the JB-199 unit.
  • Reset the BIOS setting of the mainboard following the instructions below.

    • How do I reset the mother board of JB-199 after changing battery or after it has reloaded default settings?

    Category: JB-199 (I or II)
    Permalink
    a

    CAVS JB-199 (I or II) Jukebox program doesn’t starts automatically. Also it doesn’t starts when the “JB-199 Startup” icon is double clicked in the desktop.

    Posted by CAVS on March 17, 2020

    Step 1. Check the “PCI Card” driver software.

    Make a right click on “My Computer” icon, go to “Properties”. Then go to “Hardware” and “Device Manager”. In the “System devices”, check for the “EnvyLogic Easy Target WDM Driver V1.0” device.

    If you don’t see this device, look for an “Unknown Items” tab and if it is there, reinstall the driver for it, PCI Card Driver-WinXP.zip(See Step_1.JPG).

    If you cannot to find “EnvyLogic Easy Target WDM Driver V1.0” device and you don’t see any “Unknown Items”, go to Step 2 below.

    Step 2. Take the JB-199 top cover off… and then pull out the PCI Card (See Step_2.JPG) and insert it back. You are making sure of the contacts on the PCI card to the main board. Now go back to Step 1.

    You can also check if the “PCI Card” is installed correctly or not by running the PCI Card Test. Start the test and press on the “Read ADC” button and on the “Read DS2432” button. (See Step_3.JPG and Step_4.JPG). If the test program does not freeze and you see various information displayed in a window on the bottom, the PCI Card is installed correctly. If not, go back to “Step 1”.

    Category: JB-199 (I or II)
    Permalink